Author Archives: admin

Automation and Control – Settings

So with our hardware all set up, the OS installed and everything running OK, it’s almost time to decide on the software.  I am going to concentrate on the Windows 10 IoT app first of all since that is all … Continue reading

Posted in IoT | Tagged , , | Leave a comment

Automation and Control – Hardware and OS

First things first.  To get anywhere with this project, we’re going to need some hardware.  I am not going to go deeply into the reasons for choosing what I did, except to say that I wanted costs to be minimised, … Continue reading

Posted in IoT | Tagged , , | Leave a comment

Automation and Control – Introduction

As if my life wasn’t busy enough already, I have decided I’m going to tinker with Windows 10 IoT Core, a few Raspberry Pi devices and a bunch of sensors/switches this weekend.  My aim is to make all the smart … Continue reading

Posted in IoT | Tagged , , | Leave a comment

Clara – more news

As you will have seen in previous updates, the crack in Clara’s top was bugging me.  With that in mind, and also the fact that in retrospect weight relief would have been a good idea, I decided to take the original … Continue reading

Posted in Clara | Leave a comment

Clara – Routing the pickups

The next scary part is to cut out the pickup holes.  There’s no going back from this, so make sure they are marked out in the absolutely correct location, then check the location, measure again, panic, and then think about … Continue reading

Posted in Clara | Leave a comment

Clara – Cutting out the binding channels

The time has come for some more delicate work – cutting the binding channels.  By hand.  Who had that bright idea?  Oh yes, me. First of all, I had to remember where I had put my gramil (basically a tool … Continue reading

Posted in Clara | Leave a comment

Clara – Carving and binding channels

After looking at the maple cap, and the split that appeared, I decided that it was not a write-off after all.  Yes there is a crack, but a very small amount of filler will make it all but invisible.  So … Continue reading

Posted in Clara | Leave a comment

Clara fights back

Whenever you work with wood, you have to expect it to fight you at some point along the journey.  In this case, the first time was when I was about to glue the cap on to the sapele body.  I’d … Continue reading

Posted in Clara | Leave a comment

Clara – Starting on the neck

Maybe I am a masochist, but I enjoy necks most.  This one is a simple two piece construction of sapele.  Glued up and very roughly cut, it looks like this. A bit more cutting… and (very) roughing out the headstock. … Continue reading

Posted in Clara | Leave a comment

Clara – a Build for Mr Wilson

I was talking with a friend who was looking for a Les Paul style guitar, but he had a very specific set of requirements.  He wants as faithful as possible a copy of Mick Ronson’s Les Paul.  I’m crazy enough … Continue reading

Posted in Clara, Uncategorized | Leave a comment